When off road, it is inevitable that obstacles and off road hazards will be encountered that could potentially inflict expensive damage to your differential. To prevent this, ARB manufactures the Differential Cover. Using high tensile nodular iron, it has been engineered to protect the differential and ring and pinion set from any off road hazards.

FEATURES

• Computer optimized cross brace design increases the structural rigidity of the whole axle
• Additional housing strength helps keep the ring & pinion gears meshing on the flat faces of the teeth, greatly increasing ring & pinion life and overall maximum load strength
• Top quality, high power neodymium magnets are used in both the drain plug and the dipstick to collect metallic wear particles as the vehicle moves
• Magnet location in the end of the dipstick allows the oil to be checked for tell-tale signs of internal damage
• Prolonged carrier bearing life due to extra support to the bearing alignment
• Approach/departure angle optimized by angled exterior surfaces
• Unique dipstick/filler cap design allows differential oil level to be adjusted for customized high driveline angles
• Coming in a red powder coat finish, the Differential Cover is available for Dana 44 and Dana 60 models.

Dana 60 only $169.99

Dana 44   Only $119.99

Dana 60  Only $129.99

Dana 70  Only $129.99

GM 14 Bolt  Only $139.99

The covers offer much better cooling and strength compared to the stock covers.  Finned heatsinks.  Many offer extra capacity.  Listed covers are IN STOCK, many other available in 3 days. Only $99.99

Dana 60 Rear

Dana 70

Dana 80

Ford 10.5"

Model 20

GM 14 Bolt

Clear Gearz covers are made of polycarbonate and surrounded by a PPG "Near-Chrome" Powder Coated One piece Steel Ring. This combination adds up to extreme high strength, good looks and uniqueness. Clear Gearz allows you to monitor oil levels, gear wear and the presence of moisture.
 Clear Gearz have been extensively tested and proven to be as strong if not stronger than any other cover currently made.

Installation is simple- We recommend the use of a clear Silicone sealant and a high quality of synthetic gear lube for better transparency.

Maintenance is simple-Wash with soap and water only. Chemicals such as brake fluid, gasoline, paint thinner, etc. will damage or destroy the look or integrity of your cover. In the case of light scratches we recommend the use of a Polycarbonate approved plastic polish.

Dana 60  Only $149.99

Below is the covers we stock, many others we can get in 3 days.  Only $29.99

AMC model 20

Chevy 8.5" 10 Bolt

GM 14 Bolt 10.5"

GM 14 Bolt 9.5"

Zinc coated differential protection.  Only $144.99

Includes hardware.  Only $69.99

Dana 30

Dana 35

Dana 44

Weld on Protection.  Includes magnetic drain plug and fill plug.  Front or rear.  Only $29.99

This weld on pirce will protect and brace you front axle.  Front or rear.  Only $14.99